Rough
dimensions for standard courts
(Standard Court 28.6 mm (1 1/8") front. 20.6 m (13/16") side and
back, 16 mm (5/16") ceiling)
|
NOTE:
6096 mm(20ft.) Squash court is approved for play
Consult CRS for further information |
COURTS
Singles squash (American)
Doubles squash
International squash
Racquetball/handball |
WIDTH
5874 mm (19' 3 1/4")
7855 mm (25' 9 1/4")
6636 mm (21' 9 1/4")
6331 mm (20' 9 1/4") |
LENGTH
9989mm (32'9
1/2")
13951mm (45'9 1/2")
9989mm (32'9 1/2")
12427mm (40'9 1/2") |
HEIGHT
No floor
n/a
n/a
n/a
6268mm(20'6 3/4") |
The rough
dimensions allow 6 mm (1/4") clearance from the wall
using 92 mm (3 5/8") studding and the court panels. The
floor is tongue and groove flat grain hardwood flooring over 50 x 75
mm (2" x3") sleepers. The ceiling of the racquetball/handball court is 16 mm (5/8") laminated plastic panels and 152 mm (6") x 1.55 mm (16) gauge
joists.
Exact dimension requirements (Before panels can be installed) |
|
WIDTH |
LENGTH |
HEIGHT |
Singles squash (American)
Doubles squash
International squash
Racquetball/handball |
5690 mm (18'8")
7671 mm (25'2")
6452 mm (21'2")
6147 mm (20'2") |
9811mm(32'2 1/4")
13773mm(45'2 1/4")
9811mm(32'2 1/4")
12249mm(40'2 1/4") |
n/a
n/a
n/a
6960mm(20'6 3/4") |
| Dimensions shown
are after any wall irregularities have been corrected. CRS Corporation Panels are milled
to (90-degree angles), and to within as little as ±0.8 mm (1/32") overall length. |
|
|
CUSHIONED SLEEPER SYSTEM
Cushioned Sleepers shall be 50.8 x 76.2 x
1219 mm (2" x 3" x 4') Douglas Fir or Western
Hemlock, Woodlife treated by the Dri-Vac System. Pads shall be securely attached to the
underside of sleepers approximately 305 mm (12") on center and at both ends. Cushioned Sleepers shall be placed
end-to-end, spaced at least 6 mm
(1/4") apart and on 228 mm
(9") for 19.8 mm (25/32)
flooring, or on 305 mm
(12") centers for 26.2 mm
(33/32) flooring. Overall height of this floor is 66.5 mm
& 73.5 mm (2 5/8" & 2 7/8"), respectively. |
CUSHIONED SLEEPER-PLYWOOD SYSTEM
Cushioned Sleepers shall be 50.8 x 76.2 x 1219
mm (2" x 3" x 4') Douglas Fir or Western Hemlock,
Woodlife treated by the Dri-Vac System. Pads shall be securely attached to the underside
of sleepers approximately 305 mm
(12") on center and at both ends. Cushioned Sleepers shall be placed end-to-end,
spaced at least 6 mm (1/4")
apart and on 305 mm (12") centers.
Plywood shall be exterior glue line 16 mm x 1219 mm
x 2438 mm (5/8" x 4' x 8') sheets placed over sleepers
and securely attached at bearing. Overall height of this floor is 83 mm (3 1/4"). |
RESILIENT UNDERLAYMENT SYSTEM
A layer of 1219 mm x 2438 mm (4' x
8') sheets of 12.7 mm (1/2") Asphalt Impregnated
Resilient Underlayment Board shall be laid with long dimensions of sheets parallel to long
dimensions of wall with 6 mm (1/4") space at all edges.
A layer of 19 mm (3/4")
plywood shall be laid at a 90º angle to the under-layment board with 6 mm (1/4") spacing at all edges.
Finish flooring shall be 19.8 mm
(25/32) inches thick by 57.2 mm (2 1/4") face kin dried
continuous tongue and groove and end-matched MFMA Hard Maple. Architect shall select from
first, or second and better grades. Overall height of this floor is 50.8
mm (2"). |
|
